OpenSCAD Personalized Star Ornament example

OpenSCAD examples
/

Personalized Star Ornament

Beginner

Holiday

Lesson 24 of 28

Build a star from a list comprehension, give it a bevelled top, and add a hanging loop and a custom message.

Try changing:

top_textsymbolbottom_texttext_reliefpointsouter_radiusinner_ratiothicknessbevelloop_hole

Low compile complexity. One polygon, two extrusions and short text; compiles quickly.

How this model works

Alternating outer and inner radii give a star with points sides. A second, shorter linear_extrude with scale below 1 tapers toward the center and forms the bevel. The loop is a hull of a ring and a small anchor circle inside the top point, minus the hole, so it stays attached at every star size. The message is three rows: the top text, a heart or star drawn from basic shapes, and the bottom text, raised on the bevel. Text size is estimated from the character count, so long names get smaller instead of overflowing. It prints flat; pausing at the top of the bevel lets you swap filament for a two-colour message.

Untitled project

main.scad

Loading draft

Ctrl/Cmd+Enter or F5: preview · F6: render · Ctrl/Cmd+F: search · Ctrl+Space: complete · Tab: leave editor

0 messages

Make it your own

Make a six-point star with a deeper bevel. Then set symbol to None and use a single name with a year underneath.

Change one parameter at a time and inspect the result. Use the workspace reset action to return to this lesson’s original model.

FAQ